Your needs might vary from mine. For me, an average shooter who does not shoot in competitions, I don’t think I have the need for that level of precision. As long as my loads are within a “minute of deer” I am good.
Thanks for the input. With the 2 calibers I have primarily reloaded, both are extremely accurate, but I got to reading on stuff and figured maybe I need a new "mousetrap"Most can shoot bugeye holes without using an AOL gauge so I don't see a need. IMO
Yep. Years ago I was all about improving accuracy and I even got to the point of turning the necks and weighing the cases and bullets, I finally figured out that I'm not a "great" shot so now I focus on fun. That doesn't mean I regret my pursuit of accuracy and I would do it again.Thanks for the input. With the 2 calibers I have primarily reloaded, both are extremely accurate, but I got to reading on stuff and figured maybe I need a new "mousetrap"
I posted this in the good deals thread a while back. Maybe it's not a good deal because they are still in stock.Was lucky enough to find two boxes of .308 150gr Interlock at Academy. Hopefully I can get some load testing done soon.
Sent from my SM-G965U using Tapatalk
Thanks for the input. With the 2 calibers I have primarily reloaded, both are extremely accurate, but I got to reading on stuff and figured maybe I need a new "mousetrap"
I posted this in the good deals thread a while back. Maybe it's not a good deal because they are still in stock.
https://www.midwayusa.com/product/1010474050?pid=235800
I have 200 of these and 200 of the 180s shipped right now
Sent from my moto e6 using Tapatalk
That’s a lot of swinging and smacking that hammer..
That’s a lot of swinging and smacking that hammer. Hard to find right now but I use Hornady bullet puller after I broke my kinetic hammer.
I recently finished pulling 1k of water damaged 357mags that I got cheap.
I received about 500 rounds of .38 special from a widowed neighbor. Tried some yesterday and they’re cowboy loads, very low recoil. I think I’ll get busy using my kinetic bullet puller to repurpose these. I would rather have the primers but I don’t want to damage them so I’ll just do a different load under the same bullets.
What would you guys do with them?
Sent from my iPhone using Tapatalk
Gotta try the shell holder thing and I'll remember the 3/4 pvc cap thing.I recently finished pulling 1k of water damaged 357mags that I got cheap.
Used a kinetic hammer. It was a lot of work. I put a 3/4" pvc cap on the end.to save my hammer when i started seeing stress cracks.
No the collet on the kinetic hammer doesn't damage the brass. But it is slow, so I switched to using my shell holder in the hammer and that CAN damage the rim of the brass if you go full retard.
I had a friend help, and he is retarded because he messed some up.
Sent from my moto e6 using Tapatalk
No but it can if you crank it.Does the collet mess up the bullets?
Sent from my iPhone using Tapatalk