Where did you order from, if you don't mind saying?Just ordered an SA-35. Should arrive next week.
I have a order for one but the shop I use has 5 on backorder, look forward to your results.Just ordered an SA-35. Should arrive next week.
I bought it on gunbroker. It was not $699.00, but no gun shops are selling it for close to MSRP. PSA was asking over $1000.00 and it went in seconds; GrabaGun had one earlier today for a few minutes at $1099. A shop here in San Antonio was selling it for $1400.00. I got mine for $950. More than I wanted to pay but it had just been listed with that BIN.Where did you order from, if you don't mind saying?
You are almost there.I can see y’all enjoying what you bought give feedback on how well they shoot
I love my FS.I got this beauty, but not a Beretta 92X, just a regular 92FS.
Hawk
I got my Magnum Research MR1911css back from the smith replacing the MIM parts with good tool steel parts. Shoots very well . Target is 3 mags at 3 yards and 3 mags at 7 yards 4 types of duty ammo free hand. View attachment 286739 View attachment 286741
I will always love the 92fs because of my experience in the army. I own a few, and will never sell my Elite2.I got this beauty, but not a Beretta 92X, just a regular 92FS.
Hawk
Pictures when it show up!Bought a Springfield XD-M Elite in 10MM, should be in next week to local FFL
I love my FS.
Sent from my LM-Q720 using Tapatalk
P22 was my first .22 host.New addition to the family. The P22 cracked slide thread kicked me in the nuts. But hoping this will be a great suppressor host.
First off which model did you buy? BUL who makes the pistols take a Government slide and cuts it down. The frame sits in between a government and a commander frame length. The commander uses the bushing less bull barrel to keep a bushing barrel set up from pounding itself to death. The only non mim part is the firing pin. I replaced everything else but non load bearing, ie grip safety , plunger tube , mag release, and trigger. The grips are a John Harrison design. The grip is not aggressive enough to tear your clothes but when you grip the grip the groves allow you to grip better but as soon as you release your grip a little you can manipulate the controls as needed without the grips sticking to your hand. It works well. Anymore more questions I will be happy to answer. Also if you buy parts for their commander the part will need to be government parts. I also had a Wilson combat 4" flat spring guide rod setup. Love it.I recently picked one of these up, which parts are MIM?
Asking so I can do the same.
It's a beautiful gun, did you not like the factory grips?
Sent from my moto e6 using Tapatalk
I love the original fs as well, however my fat hand with short fingers does not like it. The 92x addresses this problem.I will always love the 92fs because of my experience in the army. I own a few, and will never sell my Elite2.
Sent from my moto e6 using Tapatalk