There are variants to meet every need but this one is THE old-school classic and should be studied before going off on unproven tangents.Building a reload station, any great design advice?
Now you post this. Could have used it a few months ago.There are variants to meet every need but this one is THE old-school classic and should be studied before going off on unproven tangents.
Last night I ran about 400x 45gap and loaded a few dozen 7.62x54. also prepped some 7.7x58 brass I've been looking at for a couple weeks now. Just need to get bullets for this one.
Sent from my LM-G820 using Tapatalk
I used a lee pro1000 to load them using 45acp dies. I had already sized, primed and flared them separately. On the pro1000 I had it setup to drop powder, seat, then crimp. I know you hate Lee factory crimp dies but I used one for a little crimp.What did you load the GAP with? I like that platform, too bad it won't have any traction.
A tip of the hat to Benenglish! ThanksThere are variants to meet every need but this one is THE old-school classic and should be studied before going off on unproven tangents.
Need another friend?I got to do a “reloading good deed”! I gave a friend, who was almost out of SPP, a brick. (actually it was only 8 boxes, but I didn’t realize it wasn’t full until we met and I gave it to him!)
Sent from my iPhone using Tapatalk
Need another friend?
Will this help? https://forum.texas3006.com/viewtopic.php?f=20&t=69I scoured the internet for Trail Boss powder but was unlucky.
Bought 1000 .224 55gr FMJ bullets.
Now that my 300 blackout brass is cleaned, need to work up some loads.
I scoured the internet for Trail Boss powder but was unlucky.
Bought 1000 .224 55gr FMJ bullets.
Now that my 300 blackout brass is cleaned, need to work up some loads.