Yeah you'll get trigger pins walking out and light strikes, but you aren't going to get a run away gun.You sure? I can see a weak hammer from a backwards spring, but I don't see how it can affect the geometry of the hammer and disconnector.
Yeah you'll get trigger pins walking out and light strikes, but you aren't going to get a run away gun.You sure? I can see a weak hammer from a backwards spring, but I don't see how it can affect the geometry of the hammer and disconnector.
I found this out on an AR i put together, since the hammer and sear wont align correctly with the spring backwards. I was very confused for a few seconds playing with the lower on why the hammer wasnt engaging but everything else seemed ok and stuff when together fine otherwiseYou sure? I can see a weak hammer from a backwards spring, but I don't see how it can affect the geometry of the hammer and disconnector.
Must have walked pretty far out...The answer is the trigger pin had "walked" out. Reseated pin with detent in proper position and fired 20 rounds with no malfunctions.
We’ve been talking through messages and he said it was about 1/16”.Must have walked pretty far out...
There's no detent holding in the trigger pin, its held in place by one (or both, depending on the pin) of the struts of the hammer spring resting in a groove cut in the pin.Well I did not want to call out anybody but @Orbie you outed yoself. Anyway the pin holding f the trigger in place had come out a bit. Just enough that the detent in the pin did not engage the spring. As per my buddy, 10+ years on Army shoot team, the pin had not been inserted far enough the said this wax’s common occurrence and nothing to do with a polymer lower
I once summarized the stats on equipment (computers, a/v equipment, etc.) failures at a large conference. This was a very short summary intended for inclusion as a paragraph or less in some exec's report....overlooking something so simple.
What I called a detent is the groove cut in the pin as you describe. Detent is the term used by my friend who is more knowledgeable on this subject than I can ever hope to be. As per his words, everything else is in the right place. Test fired 25 rounds with no mishaps. Not sure pictures will solve anything.There's no detent holding in the trigger pin, its held in place by one (or both, depending on the pin) of the struts of the hammer spring resting in a groove cut in the pin.
The trigger pin is always inserted first, so it's incredibly hard to have it out far enough to where the hammer spring is not retaining it, unless the spring is backwards, or has been inserted under the trigger pin.
Is it possible to get pictures of the lower? One of the inside of the FCG pocket, and right and left side showing the trigger and hammer pins?
Well I did not want to call out anybody but @Orbie you outed yoself. Anyway the pin holding f the trigger in place had come out a bit. Just enough that the detent in the pin did not engage the spring. As per my buddy, 10+ years on Army shoot team, the pin had not been inserted far enough the said this wax’s common occurrence and nothing to do with a polymer lower
All is goodI appreciate that but I was not going to hide in the shadows and pretend I didn’t know it was me. Nobody is perfect and we have to learn from our mistakes. Unfortunately, I made a mistake on something that was no longer in my possession.
your problem is the polymer lower
Axeually that is. It the issue. Please read all my responsesyour problem is the polymer lower
He is right though. Polymer lowers are going to give you issues eventually. From snapping in half, to pin holes egging out and general poor feel on the trigger and safety, to turning into frag grenades if the gun KB's...Axeually that is. It the issue. Please read all my responses