I grew up in a smallish town. There wasn't anything legal to do there after 8pm other than goto Walmart.
Exactly what I'm talking about ... and most are open all night, thank gawd.
I grew up in a smallish town. There wasn't anything legal to do there after 8pm other than goto Walmart.
I bought my townhouse in 2013. The kitchen countertop was redone in 2004 but the particle wood equivalent of cardboard isn't holding up and the bottom of the countertop is warping and flaking everywhere. I'll probably have the countertop redone in 2-3 years. If I wanted to I could run the wood particles from the bottom completely through to the top around the sink. I don't know if it was defective particle board glue or what. It sucks.Serious question: You're kidding, right?
Unfortunately no. In the last twenty years or so, it is not unusual at all to remodel kitchens and baths in homes that are only 10 to 15 years old, and a fair number that are less than 10.
Not surprising when you consider the shoddy construction, poor materials (plantation grown construction lumber, often improperly dried, is not as dimensionally stable as lumber once was), and the unbelievably piss poor workmanship that is all too common with our current labor force.
Add to these factors the fact that much new residential construction these days uses "built-in" cabinetry (which is 'built in place' by attaching to existing walls) instead of "shop built" cabinetry (built off site, and installed on existing walls).
Because walls move, and move they will, those pretty new "built-in" cabinets (eye candy, with little structurally sound about them, because unscrupulous builders only put money where you can see it) start to fall apart ... literally. AAMOF, it is amazing what those beautiful cabinets in a brand new million dollar home in the area where I live, built in the last boom prior to 2008, look like after five to ten years.
Another factor is when one of these homes sells, the new owner wants to update the look.
Let me put it this way, I make a damned good living redoing kitchens and baths in $800k+ homes because drawers stick, doors are warped and don't close, rails and stiles become loose, and/or the old or new owner simply wants to modernize ... and the aforementioned problems make for a damned good excuse to do so.
If I wanted to I could run the wood particles from the bottom completely through to the top around the sink. I don't know if it was defective particle board glue or what. It sucks.
Thanks. I think I'll get some kind of cultured granite or something later on. I use my kitchen. I'm not into spending a ton of money on a countertop. I'll pm you when I'm gonna actually do it. End of thread jackNot unusual around a sink, especially drop-ins that were not properly sealed, or the caulking was either not the right kind and didn't last as a result.
Particle board and plywood simply do not hold up well in areas subject to moisture.
Thanks. I think I'll get some kind of cultured granite or something later on. I use my kitchen. I'm not into spending a ton of money on a countertop. I'll pm you when I'm gonna actually do it. End of thread jack
Why this thread as suddenly become quite interesting?
When mentioning Wal-Mart, and I have no gripe against their corporate attitude whatsoever, it is hard to not make the observation that "cheap", rather than "inexpensive", seems a priority of the corporate vision.
.
My only point about wallyworld is, it's the customer not the company that drives this mindset.
My only point about wallyworld is, it's the customer not the company that drives this mindset.
Well that is interesting.
Why does the church hold a major stake in Walmart stock?
There is a lot of money in churches. People make tons of cash with em. Pretty easy to start, tax breaks, lot of under the table transactions.
No way; this thread jack is good. How about "butcher block" counter-tops. I'm a bit dubious on their durability, but they don't cost all that much and are easy to repair.Thanks. I think I'll get some kind of cultured granite or something later on. I use my kitchen. I'm not into spending a ton of money on a countertop. I'll pm you when I'm gonna actually do it. End of thread jack
I looked at them and I like the looks. Durability, price and maintenance are my biggest factors. I want to have a counter I can use and clean then never replace.I had a dream last night that my local Big Lots closed without warning. Store fully stocked, but it was just inexplicably shut down. I was mad because I then had to goto WalMart for TP.
No way; this thread jack is good. How about "butcher block" counter-tops. I'm a bit dubious on their durability, but they don't cost all that much and are easy to repair.