I mounted an optic on a Glock mos model. The torx bit stripped.
I did get another t10 bit. However, i torqued it to specification 24 hours AFTER I applied blue 242 loctite. I imagine I should reapply it? Not super motivated to do that, it’s pretty low viscosity and clean up is kind of a pain.
I know some of you use the red permanent loctite because it is easier to manage as a gel. However, not wanting to take a blow torch to the optic to remove it from the slide.
I did get another t10 bit. However, i torqued it to specification 24 hours AFTER I applied blue 242 loctite. I imagine I should reapply it? Not super motivated to do that, it’s pretty low viscosity and clean up is kind of a pain.
I know some of you use the red permanent loctite because it is easier to manage as a gel. However, not wanting to take a blow torch to the optic to remove it from the slide.