Join TexasGunTalk

Cmc trigger problem

Discussion in 'Gunsmithing' started by Caseycole, Dec 1, 2019.

  1. gshayd

    gshayd Ugliest house on the block.

    1,247
    1,171
    113
    Nov 25, 2018
    Beaumont, Texas
    When you do triggers you should be polishing the parts not sanding them. Sounds like something may not be installed in the right position. Might check for any burrs on the trigger or disconnect where they meet. Make sure that you polish on the flat of the trigger parts if you are not careful you can round the edge which is not good.
     


    Mohawk600 and oldag like this.
  2. FireInTheWire

    FireInTheWire Ego kills talent TGT Supporter

    4,592
    6,523
    113
    Jan 22, 2018
    Big Country
    I've never had any issues with my CMC's. Get a 2nd opinion.
     
    toddnjoyce, smittyb and Dad_Roman like this.
  3. DoubleDuty

    DoubleDuty Active Member

    569
    513
    93
    Feb 9, 2019
    DFW
    Call them and see what they will do. Otherwise a gunsmith.
     
  4. Mohawk600

    Mohawk600 Well-Known

    1,229
    663
    113
    Mar 31, 2018
    Austin
    this^^^^
     

Share This Page