I recently bought a cmc 3.5lb single stage trigger for my ruger ar556 in 300aac. I installed just as shown in the video. After moving the hammer back manually the trigger would lock up and not fire. I would have to manually move the trigger forward while pulling the hammer back to get it to actually reset. I watched a video online about this and the guy said to sand down where the hammer (and I think the disconnector catch) and did this and took off a very minute amount and now the dang hammer won’t even lock back(which makes me worry it’ll just dump the mag when I try and fire once)... I’m sure they probably won’t take the trigger back now since I altered it, however I was seeing a ton of people doing this online. Anyone have any advice?
Ohh... I can also not move the safety selector back and forth now too unless I manually reset the trigger and hammer... -_- please help...I need an adult... lol.
Ohh... I can also not move the safety selector back and forth now too unless I manually reset the trigger and hammer... -_- please help...I need an adult... lol.