PLEASE EMAIL ME DIRECTLY, Texas.Eli@gmail.com - I may be slow to respond to PMs!
1948 Ford long-door 'Club Coupe' - the one with a back seat.
Photos taken August 1, 2018!
In my family since 1990, in storage over 26 years - since 1992!
Old 1950s or 1960s hot rod, STEEL car with very minor filler at common rust areas.
No motor or transmission, last had a flathead.
For 70 years old, the car is straight, clean, and solid!
'Open' rear end from a 1949, 1950, or 1951 Mercury installed, complete with parallel leaf springs.
ECI 5X4.5" disk brake kit installed on the front circa 1991 - will need calipers replaced.
ECI dual-chamber master cylinder kit installed circa 1991 - will need master replaced.
Unknown non-original front seat (looks right), original back seat, both in good condition - vinyl upholstery.
Small-Block Ford engine and transmission mounts from Chassis Engineering included.
Front bumper is in the trunk, both bumpers need re-chroming.
MISSING FRONT FLOORBOARD IS IN THE BACK SEAT, CAR IS MOSTLY COMPLETE!
Very solid project car! This is not some junker that’s been sitting in a field 50+ years with rusted out floors and a bad frame, this is a nearly complete and solid car.
Asking price is $8500, trades considered, cash talks and BS walks. What else do you want to know?
CLEAR TEXAS TITLE IN MY NAME!
PLEASE NOTE: Some items are parts in photos may not be included at asking price, but may be negotiated!
1948 Ford long-door 'Club Coupe' - the one with a back seat.
Photos taken August 1, 2018!
In my family since 1990, in storage over 26 years - since 1992!
Old 1950s or 1960s hot rod, STEEL car with very minor filler at common rust areas.
No motor or transmission, last had a flathead.
For 70 years old, the car is straight, clean, and solid!
'Open' rear end from a 1949, 1950, or 1951 Mercury installed, complete with parallel leaf springs.
ECI 5X4.5" disk brake kit installed on the front circa 1991 - will need calipers replaced.
ECI dual-chamber master cylinder kit installed circa 1991 - will need master replaced.
Unknown non-original front seat (looks right), original back seat, both in good condition - vinyl upholstery.
Small-Block Ford engine and transmission mounts from Chassis Engineering included.
Front bumper is in the trunk, both bumpers need re-chroming.
MISSING FRONT FLOORBOARD IS IN THE BACK SEAT, CAR IS MOSTLY COMPLETE!
Very solid project car! This is not some junker that’s been sitting in a field 50+ years with rusted out floors and a bad frame, this is a nearly complete and solid car.
Asking price is $8500, trades considered, cash talks and BS walks. What else do you want to know?
CLEAR TEXAS TITLE IN MY NAME!
PLEASE NOTE: Some items are parts in photos may not be included at asking price, but may be negotiated!