Need rechambering work!

[rio grande]

I have a simple rechambering project I need done in Houston or vicinity.
.22 lr to .22 Hornet or possibly .22 Jet.
Barrel is off-action already.
Quality work only please.
Please reply to steven52_w@yahoo.com

 

[Angered_Kabar]

You know those two cartridges are centerfire and the hornet doesn't even use the same caliber bullets as .22 lr right? I was also looking a little more and .22 jet needs a faster twist rate than .22 lr.

Probably will need to have a new bolt made, and the action it's self might be too short for the over all length of these catridges.

 

[Mikewood]

Yup, best to not go this direction as it will quickly cost more than a new gun.

 

[rio grande]

It is for a 10 inch long 12/.22lr shotgun adapter. No bolt mod necessary.
The bullet dia. difference is nominal at .002.
Many .22lr barrels have been rechambered to .22 mag. (.224 bullet) w/ no difficulty or problems.
Twist rate is not important to me as I will reload cast bullets only and vary velocity.etc to get the accuracy I require. I am not looking for a 'hot' load.

So, who can do it?